Recenzje klientów dla VEVOR imadło zaciskowe śrubowe 450 mm, imadło stołowe 170 mm, zaciski stołowe 100 mm, metalowe Profesjonalne imadło żeliwne do wiertarek kolumnowych Szerokie szczęki i wszechstronne zastosowanie

VERY GOOD PRODUCT, I WILL BE USING IT FOR SMALL MILLING JOBS.

Many reviews focus on the finish of these tables, in most respects mine was usable out of the box. I stripped it and relieved all sharp edges but found the ways to be adequately ground so just lubricated. Thrust bearings were present and the gib strips adjusted to leave free movement with no play. The only issue was the perfunctory flaky chroming of the hand wheels which I had to clean up!. For the price I was impressed but have yet to affirm the levels on the horizontal plane. Not so critical on drill press but important for milling? Overall a worthwhile purchase.

Great value for money, had to adjust the lead screws to take up the backlash but works great. A cheap way of converting a pillar drill into a milling machine.

There is a little slop in the XY when it arrives, but tightening the shims and a teardown/rebuild fixes most of it. Unless you are doing heavy milling operations--BUY IT! I turned my milling table into the XY of a DIY Lathe. So long as the shims are tight, the cuts are clean! I'm incredibly impressed by the craftsmenship of this milling table. Definitely definitely worth the money!

I received mine and took it apart and cleaned all the shipping coatings. Applied some ways oil to all sliding surfaces and spindle oil to the threaded hand wheel screws, adjusted the gibs to tighten up play/backlash. Set on my drill press and made a quick test run on some Delrin block. I was very pleased and now can use my drill press for some basic milling on light materials which is exactly why I purchased it. Mission accomplished and I'd recommend it.BTW it is very heavy so you'll most likely need to brace your drill press table - depending on its sturdiness.

The dials are in mm. The x y travel is 66mmX116mm. Solid build. The only flaw is a lot of backlash in the lead screw.

The slides are basicly good but need a bit of work. I scraped the machining marks out and scrapped the slides in. Also removed the sharp edges and the slides are great now. The cast iron is a bit on the soft side but it will be ok. I will add that I am a machine tool fitter machinist by trade.D.P.

A little rough around the edges but easy enough to square up and a solid build.Best Buy for the buck from what I found.

The slides on the table needed a little adjustment to get them to track easier and reduce sideways movement, but all in all a well made piece of kit, very pleased with it