Recenzje klientów dla VEVOR Chłodziarka przemysłowa, KH-6000, 200 W, przemysłowy system chłodzenia z kompresorem, pojemność zbiornika na wodę 12 l, maks. przepływ 7,8 l/min, do chłodzenia maszyny do grawerowania laserowego CO2

Merge Foarte bine cu laserul Vevor

Had for a while now, I got it for a budget water TIG torch water cooler and it works perfectly. It has a little too much flow for a single torch, so I just plumed both of my setups into the one cooler. otherwise having a small bypass so the full flow isn't being forced through one torch also worked fine. I can run 300amps flat out holding the torch head the entire time with no issues. literally works as good as any $1000+ torch cooler I've ever used. little on the noisy side but hardly an issue in the workshop.

Nagyon kellemes, kicsit talán kevésbé halk, mint a hasonlók, de kiválóan hűt.

Desde que compre el enfriador mi laser realiza unos cortes perfectos sin superar los 19º de temperatura. Muy recomendable.

bon produit

Looks good for now, but I need to use it longer to see if it deserves 5 stars.

Po roku użytkowania ulotnił się czynnik.

Ik ben verwonderd van de kwaliteit en stevigheid van het toestel, was ook zeer snel gelleverd

Water in the tank, connect the incoming and outgoing tubes and start the engines. Working immediately and without problems. Material quality good.

After a two weeks of the use, I am not happy how noisy this thing is once the compressor kicks in. I have set up the chiller to 17 degrees and the compressor starts working when the temperature reach 19 degrees. That is fine, but it behave strange I would say. It brings the temperature down to 18.3 degrees, then it goes up to 19 and finally down to 17. Then the compressor stops, but temperature keeps going down to around 14.5 degrees. It takes around 10-15 minutes and those are very noise minutes :) Overall, it does it's job so can not complain about that, but that noise....