Recenzje klientów dla VEVOR Pompa myjki ciśnieniowej, wał 3/4 cala, tłok potrójny, 3300 PSI, 3 GPM, zestaw wymiennych pomp do myjki ciśnieniowej, części do pompy myjki, kompatybilny z modelami Simpson MorFlex 40224, 40225, 40226

Excellent replacement on my Dewalt pressure washer. Great pressure. Simple installation.

Pressure washer unit was an easy install. Super powerful. Pre-filled with oil; ready to use. Works great !

perfect

as long as every specification is read the application is perfect the pump quality is exemplary. I have used many products ordered and they all work as good if not better then other competitive brands. I will be a life long customer.

Works good no complaints

Montée en lieu et place ! quelques modifications pour les raccordement tuyaux + rajout manomètre Parfaitement fonctionnelle Correspond Parfaitement a mes intentions 😃😇😉 Petite attention au longueur vis btr dans le bloc moteur ( rajout de rondelles)

The unit appears to be very well made. all its components appear correct. my unfortunate issue is that my pressure cleaner requires a water pressure switch to allow it to start. this unit does not provide any ability for this to happen. if the pump is a straight pressure cleaner with no safety devices attached to it. this probably will work perfectly. if you purchase this unit for a pressure cleaner like mine and have to take it to a shop to modify it to fit your unit, the least expensive shop I found in my area is $168.00 per hour plus parts. other than that is a beautiful unit. VEVOR is a great company with Great products. I did submit all this pictures and questions to Their technical support and they stated that it would work. that is why I purchased it.

Pump works great! It's exactly as described and mounted quickly and easily. Would recommend and buy again if needed.

Excellent product

Ordered the 3700 PSI pump to replace a leaky AAA pump on my Dewalt 3500 pressure washer. I did not use the allen bolts that came with the new pump, I instead re used the factory bolts. Installation was simple, but the area where the bolts go is crowded, and the easiest way to get the bolts started is to slide the pump on just enough to get the bolts started. You want to leave about 1/2 inch space from the base of the pump to the motor. This gives you the room for the bolts to drop in and get started several turns before finally pushing the pump all the way in. Pump obviously has more pressure than the old one, and blew a hole iin my pressure washer hose. It was the original cheap PVC 25 ft hose that came with it, and it is several years old so I just replaced it. The small allen screw on top of the red knob will increase the pressure (it has a 10mm nut as a set screw). My pump came adjusted to around 3000 psi, and I maxed her out to get the full 3700 psi