Recenzje klientów dla Giętarka do blachy VEVOR, przenośna giętarka do blachy 1220 mm, prasa krawędziowa, kąt 0-135°, zakres gięcia, stal niskowęglowa o grubości 20 mm i aluminium o grubości 14 mm, z uchwytami, do gięcia metalu

Works great as described Item is not painted and was rusty out of the box. I was not happy to see a brand new item rusty like this. I decided to keep it and just paint it

Good quality

You will want to mount it as firmly as possible and to a sturdy mount at that. You don't want a light table, you'll only flip it all over trying to bend something.

Works as described!

Had to gusset in the middle, and the handles bent on first use. Will bend stainless steel, but its a struggle

Bought to make my own window flashing. Nice solid brake for a great price.

Excellente qualité, Parfait pour le prix.

This break is amazing. Works as advertised. I am thrilled. Getting much work done. Am about to replace rocker panel.

well built very sturdy pretty easy use easy to fold

The overall build and usability of the bending brake is quite good. It is quite heavy and suited for the job. The edges on the base, knife and anvil are all straight and sharp. There are just a few minor craftsmanship and and quality control issues. The first is the handle on the left side does not fit. The shaft on the handle is 9.8 mm, but the hole into which it must fit is only 9.6 mm. While this is easily remedied with a 3/8" HSS drill bit, it should be necessary. The right side fits just fine. The set screw for the knife depth on the left side was almost all the way out. Again, this seems like a minor and easily remedied issue, but it is likely the reason the angle bracket holding the screw on that side is ever so slightly bent. This probably occurred in shipping, but would not have happened if the set screw had been set flush. There is also signs of rusting at this corner, which are apparent at various places on the entire tool. This was present when the tool arrive, and it has been stored in a controlled environment since then. Again, minor and easily remedied. Again, it shouldn't be necessary. And finally, the instructions specify the bending brake should be fastened to the bench with 3/8" bolts. The holes in the base are too small for that. You will need to either use a slightly smaller bolt or drill out the holes to match. None of these issues are show stoppers, and I still highly recommend the tool.