Recenzje klientów dla Przecinarka plazmowa VEVOR, 65 A, łukiem pilotującym bez wysokiej częstotliwości – z funkcją 2T/4T i regulowanym czasem PT, wyświetlaczem cyfrowym, falownikiem IGBT do napraw domowych i warsztatów

Received this unit today, set it up and tested it. Instructions beyond labeling of components are non existent. Troubleshooting is for a welder! After a couple of hours of screwing around, I found that 4 of the 5 tips I was shipped were defective and produced only a very weak spark. Luckily one tip worked so I could verify that the unit was operable. The electrodes also look very cheap, so I would recommend shopping for some higher quality consumables right away, and you'll have to Google the settings for air pressure, 2T vs 4T operation, current settings etc. The unit seems ok, but it's frustrating trying to troubleshoot multiple faulty components on a new unfamiliar item. Picture of my faulty parts below for reference.

It does fine with small cuts but if youre trying to make long cuts it tends to overheat and shut off. Ended up buying an Arc Captain Cut65MP and am so happy I did.

Leider liefert das System nur 33 A Ausgangsleistung und keine 65 A - wie versprochen Nach einigem Hin und Herr mit der Hotline wurde der Kaufpreis dann aber rückerstattet

For cutting thin players it is good, but I needed plazma for 2mm metal cutting so it barely makes it.

Having problems getting this thing to work properly. No number to call for support. Online bots were no help

Bonjour . Malheureusement l'appareil ne fonctionne pas bien . Des la mise en route il s 'allume et en suite s'éteint tout seul plusieurs fois avant de pouvoir commencer a découper.

so far 1/5. out of box failed - Pilot arc does not function, looks like high frequency cct is likely the issue. - 4T also does not work.. 4T functions the same as 2T.

premiere utilisation et la torche crache des flammes par la gachette ,je viens de poser reclammation on verra bien , pour le moment c'est 1 etoile et zero si je pouvais ,suis degouté

Ha funzionato bene per le prime ore, poi ha iniziato a interrompersi a metà taglio. Si è arrivati ​​al punto in cui era difficile mantenere stabile l'arco plasma... Ho comunque finito il lavoro, ma consiglio una marca più costosa, come Telwin, se si deve tagliare molto acciaio. Quando ho finito di tagliare la vecchia caldaia a gasolio, non riusciva più a eseguire tagli lunghi più di un centimetro prima di interrompersi, anche dopo aver sostituito gli ugelli della torcia.

I dont like it he wont cut more than 5 sec without stoping