Recenzje klientów dla Ramię wciągnika elektrycznego VEVOR o udźwigu 600 kg, uchwyt wciągnika, ramię obrotowe z prętem, stalowa rama wciągnika, obrotowy podnośnik rusztowania 180°, ramię wciągnika, ramię wciągnika do warsztatu i garażu

I used U-bolts to fasten as recommended by another review and worked perfect. Easy to assemble and well-made.

bin sehr zufrieden, tut was es soll (Kübelpflanzen in den Keller befördern) Montage war auch zügig gemacht

Rigid construction as advertised. It will require trimming until you find the correct distance between the top and the bottom bases.

Nog niet gemonteerd, maar ziet er veelbelovend uit. De bevestigingsbeugel moet nog aan gepast worden aan de H-balk waaraan deze wordt gemonteerd. Toekomstige functie is het hijsen van banden van klanten naar de opslag op zolder.

L'ho acquistato x sostenere il gancio del paranco Mi serve x sollevare dal giardino al primo piano di casa la legna

Der Stützarm macht was er soll, lässt sich einfach hin und her schwenken. Lackierung ist nicht zu 100% perfekt aber nicht wieter tragisch. Kann ich jedem empfehlen.

Reçu aujourd'hui, pas encore installé, mais la qualité a l'air d'etre là, Pour les personnes qui demande pour la facture, allez dans "mes commandes", puis "détails de la commande", puis cliquez "emettre une facture"

super tevreden over de kwaliteit en prijsverhouding ervan.in combinatie met electrische fietstakel .

I installed mine on a 6x6 post on the lean-too of my pole barn with some square u-bolts. Its easy to install and seems to work well. There is one very important thing missing from the instructions which I think makes this jib hoist dangerous. If you are utilizing the extended tube, which I did, the lower pivot pin assembly needs to be turned upside down. With a hoist installed on the end of the extension tube the end of the hoist arm on the pivot pin is being lifted up. You are now depending on just the cotter pin not shearing to keep it from failing. I turned mine upside down installing the thrust bearing first. It works just fine that way and there is no risk of the cotter pin shearing. I did not realize this until I had mine installed. Not sure why this is not in the instructions. I am a Mechanical Engineer by trade so I have some idea of what I am talking about. Keep this in mind when installing. My 2 cents.

TUTTO OK