Recenzje klientów dla VEVOR 37,77 cm³ benzynowy wbijak do słupków ogrodzeniowych w kształcie litery T, 4-suwowy wbijak do słupków ogrodzeniowych z 2 głowicami (55/70 mm), przenośny wbijak do słupków o mocy 1000 W do gospodarstw rolnych, ogrodzeń rancz, ulepszeń dróg

The service was fast, but the machine has not been used yet... Weather too Hot!!!

I used it to pound 15 fence post in the ground and had to tighten and put lock tight on then. Otherwise I love the machine

For the price of renting, you buy one. Works great!

Good product. Easy use. Arrived with transport box broken during transportation. No new parts supplied after weeks of discussion - compensation instead. Customer service again.

Product performs as describes. It is heavy, but that is the reason it performs!

used this to drive Lifetime Steel Posts. "How did you a 4" wide post firnin a 3.94" hole?" you might ask. we compressed the post slightly across.the width using 2.5" 5/16" bolts in the top two holes. worked like a champ! and this machine starts with the lightest pull I have EVER seen. it is amazing.

Pretty decent rammer. Needs a short break in stretch to get full power. Definitely need to adjust the speed control occasionally. Don't run it absolutely full out. Back off a little, you get better results. This rammer is no joke. Heavy. You all better hang on tight to it Need good upper body strength to control it to keep it centered. Only used it on T posts so far, solid results driving 90 posts so far.

Starts every time, good on fuel and probably as heavy as I'd like to go for this type of machine that sometimes needs lifting above shoulder height. Interchangeable collars are handy although if the star pickets is slightly larger the opening is so precisely cut that a slight dimensional change in the head of the picket won't let it fit. Great for soft ground. Won't push through small rocks and shale though. Needed to go back to the manual version to get through the rocky area.

This tool saved me many hours of work, and I really could not have done this job without the post driver. I used it to drive 2x6 boards into the ground in front of a lake wall to seal the areas undercut by the lake eroding the soil under the original wall. I tried driving these boards in using a sledge hammer into a heavy clay soil (lake bottom) and was only able to get 8" deep. The post driver was able to get to an average depth of 15 inches. I made an adapter (on 2nd board from right in the picture) to connect the driver to the boards. Like other have noted, using the low speed, just a bit above idle worked best. And when it reaches a point where no further progress can be made, stop to avoid breaking the tool or your work. It is slow but steady. Super easy starting.

To znaczy, że dostałeś wspaniały prezent od mojego syna