Recenzje klientów dla Podnośnik silnikowy VEVOR, uchwyt silnika 340 kg, podnośnik pazurowy do silnika, uchwyt skrzyni biegów, podnośnik samochodowy do silnika z 4 kołami i uchwytem 508 mm, ruchomy podnośnik do silnika, narzędzia do naprawy silnika

Good price, cheaply built which was expected. Wheels don't roll well, paint is mismatched. Had to pop out the metal where it wasn't stamped out fully. Engine tilts down because the build materials are weak. Definitely wouldn't try to max capacity. This is just a 5.3 engine.

Hardware was incomplete but a trip to ace fixed it. I like it when I don't have to do that and it comes with everything. Instructions were bad, for the bolts it did come with they should come separated not thrown in one bag, very hard to figure out what goes where

These buckle under the weight of a small block Ford with just crank and rods. I'm afraid to assemble a full engine on this because it is very unstable. The arms don't work well for sbf or sbc. I'm going to beef it up some and use. I bought 2 of these not expecting much.

Stand is ok. However I ordered another one from Temu for half the price and it's the exact same vevor stand

This thing is hard as anything to spin any engine on it….i would never repurchase sadly…it does get the job done though

Functional, but very, very poor build quality.

When I put this stand together one of the front wheels was 3/4 of an inch off the ground. I was very disappointed in the quality of this engine stand.

À dater de ce jour je n'ai toujours pas reçu ma commande qui date du 29/04/2026

You get what you pay for. Sure it's reasonably priced, but that's really the only good part. First, the biggest issue was the holes were machined incorrectly, preventing you from being able to bolt it together properly. I had to drill an additional hole to assemble it. Secondly, there were multiple errors in the instructions, for something that is simple enough to not need instructions. The locking pin to prevent rotation is severely undersized for the machined hole, allowing a lot of wiggle when an engine is being held. There is no pocket or bracket to hold the handle when not being used either. Overall, you're better off buying this elsewhere or even finding a heavy duty used one off marketplace. Would not buy again and would not recommend.

They put large casters on the back of the stand where the upright goes. Makes the angle downward when you mount the engine. Then when you try to rotate the engine the collar where the engine mounts slips downward and you can't get the locking pin back in so the whole engine will flip over. Really sucks trying to work on the engine and makes the stand useless except for just storing the engine. Garbage, do not buy!