Recenzje klientów dla Szyna prowadząca VEVOR do ręcznej pilarki tarczowej, zawierająca 4 aluminiowe szyny do pilarki tarczowej o długości 700 mm i 3 elementy łączące, kompatybilna z różnymi markami pilarek zagłębiarskich, do projektów stolarskich

Poor quality, not square, rubber edge all twisted and falling off. Would not recomend.

Bad product out of the box with rubber strip falling apart. Brand new useless product.

I got it because it said it was going to be compatible with Makita and festool , it’s not the track too big and the track saw doesn’t fit

Rail op zich is goed maar de rode kunstof glijstrippen laten los en moet je opnieuw vastzetten.

Does not cut straight . Do not recommend. It’s only good for small 24” cuts anything greater there’s alot of discrepancies.

Glidskenor släpper och passformen när man sätter ihop dem är inte i nivå med andra tillverkare.

L'objet est reçu bien emballé, aucun problème de ce côté-là. La qualité des assemblages métallique est là, par contre un gros problème sur les bandes rouges de glissement. La colle ne tient pas ! la scie plongeante ne glisse pas ! Je regrette simplement de pas avoir mis 30 € de plus pour un produit de qualité et fonctionnel. C'était ma première commande chez vevor. Je ne pense pas m'arrêter sur cette mauvaise expérience. A voir

The "low-friction glide strips" have started to peel away from the track which isn't good and the grub screws for the joiner actually deformed the aluminum on the top side with minimal torque. I applied only enough torque to keep the halves from separating and that resulted in four small bumps on the top side which do not cause a lot of issues but it does cause the saw to lift slightly while passing over the bumps which means the cut isn't perfect. The price was right though. I just wish it were a single 55 inch piece instead of two 27.5 inch sections then the joint wouldn't be needed.

Upon tracks arriving, straight out of the box the orange rubber strip on top and the splinter guard strip’s adhesive was debonded and falling off. Not to mention when putting 2 tracks together they don’t meet flush and cause the saw to get stuck while sliding. Contacted customer service to return them and to start with they only wanted to credit me $20 and told me to go buy some glue. When I said no they finally offered to exchange them or I could return for a refund, with a caveat though. Since the box they were shipped in had seen its better days I was expected to pay for packaging out of my own pocket and drive 40 miles to the closest FedEx facility to me. I have refused and am currently waiting for a reply. Before you say I’m being petty, remember vevor is trying to establish itself as competitive with other tool companies on the market, and good customer service goes a long way with this. So far I am woefully unimpressed with the product or customer service…

I am extremely disappointed with the quality of this track rail. All of the adhesive strips on the rail are loose. Some were already peeling off out of the box, and even after pressing them back down, they do not adhere properly. The black anti-slip strips on the bottom have the same problem. This raises serious concerns about quality control. For a precision cutting system, stability and proper adhesion are critical. If the guide strips are not secure, the accuracy and safety of the cut are compromised. Although this product is relatively inexpensive, I would rather pay $10–20 more for a reliable major-brand product. I have used and liked other VEVOR products before, but this plunge saw and track rail combination does not meet acceptable standards. Due to these issues, I will be returning both items.