Recenzje klientów dla Szyna prowadząca VEVOR do ręcznych pił tarczowych, zawierająca 2 aluminiowe szyny do pił tarczowych o długości 700 mm i 1 łącznik, kompatybilna z różnymi markami pił tarczowych, do projektów stolarskich

I got it because it said it was going to be compatible with Makita and festool , it’s not the track too big and the track saw doesn’t fit

Ne glisse absolument pas avec une scie Makita. Il faut forcer comme un malade pour que la scie avance et attacher le guide.

Bad product out of the box with rubber strip falling apart. Brand new useless product.

The "low-friction glide strips" have started to peel away from the track which isn't good and the grub screws for the joiner actually deformed the aluminum on the top side with minimal torque. I applied only enough torque to keep the halves from separating and that resulted in four small bumps on the top side which do not cause a lot of issues but it does cause the saw to lift slightly while passing over the bumps which means the cut isn't perfect. The price was right though. I just wish it were a single 55 inch piece instead of two 27.5 inch sections then the joint wouldn't be needed.

Rail op zich is goed maar de rode kunstof glijstrippen laten los en moet je opnieuw vastzetten.

Does not cut straight . Do not recommend. It’s only good for small 24” cuts anything greater there’s alot of discrepancies.

Glidskenor släpper och passformen när man sätter ihop dem är inte i nivå med andra tillverkare.

Would not fit the stool saw. Total garbage could not get a refund only $20 back

L'objet est reçu bien emballé, aucun problème de ce côté-là. La qualité des assemblages métallique est là, par contre un gros problème sur les bandes rouges de glissement. La colle ne tient pas ! la scie plongeante ne glisse pas ! Je regrette simplement de pas avoir mis 30 € de plus pour un produit de qualité et fonctionnel. C'était ma première commande chez vevor. Je ne pense pas m'arrêter sur cette mauvaise expérience. A voir

Upon tracks arriving, straight out of the box the orange rubber strip on top and the splinter guard strip’s adhesive was debonded and falling off. Not to mention when putting 2 tracks together they don’t meet flush and cause the saw to get stuck while sliding. Contacted customer service to return them and to start with they only wanted to credit me $20 and told me to go buy some glue. When I said no they finally offered to exchange them or I could return for a refund, with a caveat though. Since the box they were shipped in had seen its better days I was expected to pay for packaging out of my own pocket and drive 40 miles to the closest FedEx facility to me. I have refused and am currently waiting for a reply. Before you say I’m being petty, remember vevor is trying to establish itself as competitive with other tool companies on the market, and good customer service goes a long way with this. So far I am woefully unimpressed with the product or customer service…