Recenzje klientów dla VEVOR Zestaw frezów, 15-częściowy zestaw frezów z trzonkiem 6.35 mm(1/4 cala), plastikowa walizka, narzędzia stolarskie dla profesjonalistów i początkujących stolarzy, do drewna, płyt MDF, płyt wiórowych, sklejki

Great looking bit set,haven't used them yet but I don't see a problem with them. The look to made good

Haven't used yet, but it appears to be a nice assortment of bits.

fait son boulot

Shipped fast and well packaged. Would definitely recommend to others. These bit do a great job and I really like the wooden box the came in for storage.

Je n'ai pas prêté garde les fraises sont en pouce et non en mm.

Nice bits for the occasional woodworker. Probably not the highest quality but certainly sufficient for the hobbyist. I'm very satisfied with my purchase.

Satisfait dans l’ensemble. À voir dans le temps

They seem to be good quality. Unfortunately when I received the package the bits were out of slots and just bouncing around in the box. All in all, good product and fantastic price.

The stile & rail set - ogee bit - II was assembled out of alignment. I disassembled & put back together & it seems ok. Both the bit I & bit II are assembled with split ring lock washers & standard nuts - I will replace with nylock nuts as I know these are safer for such. Thanks!

Hi All I purchased these router bits from Vevor because of satisfaction with other Vevor products. This set has a god variety of bits, and i wished to experiment with results. Most of my work has been with pine, but i have used hardwood, fence palings, mdf and plywood. I have made 4 garage workbenches 1200 x 900, rounded the mdf table top and the legs and second shelf. In addition i have made about 20 wood signs varying from 300x 150 all the way too A4 and A3 in size Roman ogee is the nicest, but most common that i use is the corner 9.5mm, cove 6.35 and champher 45 degree for edges After using plastic stencil for lettering i ended up transferring the 2 most common fonts to 3mm plywood, it was done with the 1/4 inch 90degee V which does all of my lettering ( font size 20 to 40mm in size ), it did not cut through the 3mm - i could have easily set it deeper to cut by my concern is the V would be to large at the top and i use a 1mm text pan for outline - so i used for the first time the 1/8th straight bit the plywood sat on old cardbord box and i broke thought and carved all the letters easily. At this stage i am guessing i have done about 600 meters of routing with these bits Routers are a large bosch plunge router and recently i added the vevor hand trimmer Regards George Pretty happy with the results, the bearing type straight bits also have there use but i have only used them a few time.