Recenzje klientów dla VEVOR Hydrauliczny podnośnik samochodowy z pompą pneumatyczną 20 t, podnośnik hydrauliczny pneumatyczny, skok 145 mm, czerwony, z prętem przedłużającym 100 / 300 / 500 mm, siłownik hydrauliczny do elektrostatycznego natrysku proszku, naprawa samochodów

great product for price

Great product that gets the job done when needed for a great price. Highly reccomend vevor for anything they sell which is almost everything.

20 ton is probably over kill for most of my uses but it performed nicely for my need. Hard to imagine anything related it wouldn’t work on.

Bien reçu mais je ne trouve pas comment avoir une facture?????????????????????????????????????????????

This was bought for one job to get a ram pin off an excavator, particularly difficult removal with this on full load heat and the extractor bolts eventually it broke free! Another team on this excavator with the same difficulty removing well worth just the one job as it saves the excavator from the scrap. Really a good tool with 4 stars on quality due to the poor o'ring on the filler.

I have no complaints with the VEVOR 20 Ton Porta Power. When I received and unpacked everything I saw the threaded collar that I believe keeps in place the oil seal on the ram end had fallen off and was just loose on the ram. I screwed it on and snugged it up. The only advise I can give with it's use is make sure the load is perfectly centered on the ram. If it's pushing to one side the ram will extend and may not retract. I bought this to replace a HF 10 ton where the ram seals turned to mush and leaked badly and I couldn't get any reply for replacement parts. I've been using it with a jig I made to disassembly large wooden crates made of 2-4 inch thick wood that I will reuse. So far it has been working well and I hope it lasts. The ad stated it comes with Tough Blow-molded Carrying Case whereas I received a steel case. I was happy to see that for as much as this tool and attachments weighs I doubt plastic would hold up well. Pros; the case has good sturdy latches and double handles on each end for lifting. Cons; Of the 7 spot welds for holding the lid only 1 in the center held any thing. I drilled out and pop riveted the case top to the hinge. Next step, attach the caster wheels to the bottom. The bag of the casters and screws was torn open and a few screws were in it but most I found inside the bubble wrap on the tool and accessories. One screw here, a couple nuts there, and washers in other wraps. I was 1 screw short and 2 had no threads. The case itself had 1/4" burrs on all the punched holes for the casters so I had to deburr them first as the screws were too short to start on the threads. After that 1 hole on each caster mount had to be redrilled as it wouldn't match to the caster. Over 2 hours later the case was assembled to hold everything.

****DO NOT PURCHASE**** These porta powers are absolute garbage. I purchased two of these for the shop and neither worked right out of the box. I contacted Vevor regarding this issue and asked that these be replaced. I have received nothing but a run around. This irritates me as i received the same bs run around for several mag drills that i purchased. Vevor, your customer service is atrocious, and you should be ashamed!

This tool would be more useful if you didn’t have to hold the pump upside down to use

Had a problem with the ram not retracting when I opened the valve after the second time using. Managed to sort out the problem but would have expected this not to have occurred with a brand new tool. Came in a metal case with wheels which was an unexpected bonus.

It's full of fluid but it doesn't have the pressure it needs to push. You can pump on it and it hardly pushes even the slightest weight and when you but it behind the smallest amount of weight it dosent have the pressure needed