Recenzje klientów dla VEVOR 6 L cyfrowa ultradźwiękowa myjka do płyt ze stali nierdzewnej, 33 x 18 x 28,5 cm ultradźwiękowa myjka urządzenie ultradźwiękowe podgrzewanie cyfrowe okulary zegarki biżuteria

I have used it a couple of times to clean lawn mower carb...nice that you can set longer cleaning times and heated solutions!

Love it. Just don't like that the heat is not on a tomer

IhN jeppis

Great ultrasonic parts cleaner for the price. I’ve used this VEVOR cleaner on several automotive and mechanical parts, and it does an excellent job removing grease, grime, carbon buildup, and dirt from areas that are almost impossible to reach by hand. The heater gets the solution up to temperature nicely, the controls are easy to operate, and the ultrasonic cleaning action works surprisingly well on stubborn buildup. The stainless-steel tank is sturdy and easy to clean when you’re finished. It has saved me a lot of time compared with scrubbing parts by hand. If you work on engines, carburetors, small engine parts, or other mechanical equipment, this is a very handy machine to have in the shop. I’m very satisfied with it and would definitely buy it again

Pas encore utilisé je l'utiliserai la semaine prochaine on verra après utilisation

Good, does what it says.

It’s better than expected. We have been clean8ng up some old Bakelite records and this Is definitely making a big difference. It’s definitely been worth the money and is a great little machine.

Attention , si vous remplissez raisonnablement la cuve jusqu'au trait la contenance est de 1.85l et a ras bord 2.85 l mais cela déborde en fonctionnement .

Distilled water - 5.5 l Isopropyl alcohol (IPA) 99% - 100 ml Kodak Photo-Flo 200 - 15 drops Cleaning time 15 min Cleaning 1. Fill the bath with distilled water. 2. Add IPA and mix 3. Add Photo-Flo 200: 10–20 drops total. 4. Add distilled water to the mark 5. Heat to 30°C (this takes about 40 min) 6. Place the plates in the rotating rack and turn on the ultrasonic cleaning (10–20 min). After ultrasonic cleaning: 1. Rinse the plates with clean distilled water (with a spray bottle over the sink) 2. Place the plates on the drying rack 3. Insert the dry plates into new plastic sleeves

Hello The machine Works very good, but : Why does it Come rust in the bottom ? What can i do to remove this .