Recenzje klientów dla Wał przegubowo-teleskopowy VEVOR do ciągnika, 34,9 mm, wał przegubowo-teleskopowy, końcówka z okrągłym wielowypustem T4, przedłużany wał napędowy 1000-1400 mm do maszyn rolniczych, kosiarek, glebogryzarek, czarny

Nice worked out great

This PTO shaft more than met expectations. I have an old and unknown brush hog and one of my cross bearing went bad. I spend more on trying to find the correct cross bearing, which I never did find, than I did on this PTO shaft which is the entire drive shaft. Expect to pay 3 to 4 times more at you local ag. store.

The quality and service have been very professional

Worked great. The locks on it didn’t bind up . The shaft itself slid freely like it was supposed to and worked great with my snowblower.

Worked as it should, seems to be holding up, much cheaper then some others I looked at, definitely recommend

I was very skeptical about this at first because I had just bought the same sized one from Tractor Supply Co and it cost over $450, but when I found this one from Vevor for under a $100 I didn’t think it could be good. I went ahead and bought it as a backup. Turns out I twisted the one I had from TSC and had to use this one a day after I got it. I mowed over 80 acres with this PTO shaft and hit some hard objects like trees and brush. It survived! Not only did it survive it is perfect. I thought for sure it would be bent and twisted. It wasn’t. It still telescopes in and out perfectly. Blew off the debris and it’s perfect. I cannot emphasize enough that this held together perfectly when the other one didn’t for 1/5 the price. If you’re in doubt just try this one out.

The PTO shaft - was my first order through Vevor - everything about the order was perfect; the pricing was amazing (1/2 the price), it was shipped quickly without damage. The forks are strong and fit over the lip of the tractor bucker well - their is a minor manufacturing flaw and a design flaw: One of the tightening bolts threaded connector to the fork is welded incorrectly causing the side of the bolt to rub against the side of the fork bolt chase see image). The fork screw -down clamp bolts look like they are supposed to have flat contact surface that 'should' allow the bolt to tighten without causing the round contact surface to 'walk' on the bucket. This is a problem and a better contact point could easily be designed that would not walk on the bucket surface (a design that would allow the bolt to tighten without the contact surface turning with it). However, with that said, I greased the bolt into the nut/contact surface and left the bolt about 3/8" from the contact plate which allows for the contact surface to better seat while tightening down the bolt - the contact surface still walks on the bucket, but not as much.

Very good for the price

As described works great for my brushhog. Thank you vevor for another great product. Couldn't brush hog for less

Great shaft, worked better than expected.