Recenzje klientów dla Odpowietrznik hamulcowy VEVO 5L, odpowietrznik hamulcowy 4,5CFM, odpowietrznik hamulcowy pneumatyczny 370cm

I can’t get a single adapter to seal. I’ve tried on several different master cylinders and not one I’ve tried will work without leaking badly. I’ve had different pressure bleeders in the past and none of them were as bad as these adapters.

None of quick release adapter can plug into securely. VEVOR should either change the adapter for US use or provide a quick release adapter which same as the one to connect bleeder cap . Bleeder caps are made of plastic but not fit most Japanese vehicles. To use this bleeder kit, you may need to purchase a new metal cylinder caps set which cost almost the same price as this bleeder tool. Picture shows the copper one is for US, so the quick release cannot plug into it securely.

I bought this and I have used them before. I'm a professional technician and I found that the one adapter that I've tried to use which is the most common no matter what you do you will not get it to seal the pressure bleeder I give five stars to the adapter set I give three

machine works great. None of the adapter fit any vehicle we have tried i.e ford, chevy, toyota or subaru. Had to adapt pieces to make work

The main unit itself works great. Brake fluid is easily controlled, but every adaptor I used leaked like crazy. Realized that the injection-molded caps needed some RTV between the cap and the gasket. Once done, I had no more leaks. Was able to bleed my brakes in 20 minutes by myself.

Mine didn't come with any instructions at all. So It took me a while to get up to speed with it. The first vehicle I tried it on, a 2004 dodge ram pick-up, the master cylinder adapter did not fit properly. Among all the other adapters, there was no way to make something fit so that I could pressurize that master. This is pretty common vehicle, so I find it disappointing that I already have found one that can't make use of this tool. Hopefully, this is not going to be the case with other vehicles. If I have better luck in the future I'll add to this review. For now, there's really nothing good I can say about it...

Accessoires manquant pour la bouteilles de purge, et les bouchon de vase de liquide de frein sont de mauvaises qualités ainsi que le flexible transparents... Ca ne vaut pas plus que son prix voir on se fait un petit peu flouer

Top for GM rectangle shaped master cylinders will not seal under any circumstances. Tried several different ways to support it or stiffen it, to no avail. Simply does not work. Pressure release valve kept blowing. I turned compressor down as low as it would go, 20 psi and valve kept releasing. Cables for holding plate to master cylinder are way too long, had to put a 2x4 block under master cylinder to take up the slack in the cables. I would not recommend this tool.

The problem with this unit is that the caps for the master cylinder are cheap quality. The unit itself is well made, but, in my opinion, way overdone. I borrowed a kit from my neighbor when this one failed me that was nothing more than a plastic bottle with an air hose hooked to it And a set of very high-quality aluminum master cylinder caps. His set worked like a champ. This thing has the bladder in it, which is way overkill for what the system is supposed to do. The bladder gets inverted and causes more problems with getting the fluid in the unit. There really are too many issues with this unit to describe. I have had great success with Vevor tools but this one is a dud.

Pressure tank works great break caps sucks it leaks all over can't even put 10 psi without it leaking break fluid out very bad design wish they had better pressure caps then it would work great it must be cheep china CRAP would not buy this ever again !!!