Recenzje klientów dla Zestaw VEVOR do wiercenia otworów kieszeniowych, trzy otwory kieszeniowe z kluczem i wiertłami kwadratowymi, prowadnica wiertarska do kołków do wiercenia otworów kieszeniowych i otworów skośnych, pomoc do wiercenia w obróbce drewna i aluminium.

Użytkownik nie pozostawił żadnych pisemnych komentarzy.

Het product is in de tekst in mm aangeduid, echter staan er op het product geen mm maar inch dit wordt in Europa niet gebruikt.

Clunky and some of the attachments didn't fit properly

I originally wanted to get a metal pocket hole jig for durality. However, I've used it only a few times and the drill bit consistently shaves off metal from the jig. There's enough play in the jig now that there is no way to consistently drill holes. I can't recommend another brand enough, just pay a higher price and you won't have to replace it in a few uses.

Love this jig but haven't had long . Was doing a slat wall pre drilled all my holes started putting up and realized all the heads of my screws stick out. Got to looking and the holes are wallered out. Jig is useless now . So is my project

The tool has a great price but is not built to last. Ideal for someone needing to make a few dozen pocket holes, but does not stand up to repeated long term use. Bushings and bits quickly wore down.

Primer uso y se atascó

Too much plastic and very cheaply made. Will not last too long if used repeatedly. The sizes it grips is limited.

Funkar bra för ett fåtal hål, men styrningarna för klena glappar efter ca 100 hål. Detta gör att efter ett tag blir hålen lite olika vinklar då alumimiummaterialet äte upp av borren Lätt att ställa in och skapade för material upp till 40mm.

For the price the pocket hole jig is decent. The reason for it being decent and not great is due to two reasons. 1. When the jig is not mounted to a work surface and applying the clamp with a significant enough pressure to hold the material so it doesn't move when drilling, the base that the clamp is mounted to, it will begin to warp. 2. The biggest complaint is that the drill guides are steel sleeves at the top of the holes. Whereas they are aluminum at bottom next to the material that is being drilled. Once the drill makes contact with the material, it pushes the drill into the aluminum jig and starts to shave some aluminum away. The more holes you drill, the more the guide holes wobble out. After a couple of dozen holes, the guide holes on my jig can no longer consistently drill holes accurately.