Recenzje klientów dla widły do ​​palet VEVOR 1490x70x230mm karetka wideł 907kg nośność widły 149cm długość całkowita z ostrzem wideł 109,2cm wózek widłowy 495-915mm regulowane zęby wózka widłowego ładowacz czołowy rama paletowa

Works great for piles of branches, easy to scoop pile and take to burn pile and dump. easy to clamp forks on, they stay on well, have 2012 New Holland boomer 20 tractor. Was able to unload pallet with a 3.0L engine with the forks.

Delivery man was great product good quality good price easy to use haven’t tested them too much yet butthonk they will be great

Only had a short time, but seem to work great. Will definitely help with moving tubs for cows. Easy to put on bucket and adjust.

These came in handy when we had material delivered to the farm. They will tend to losen after some use so keep a rubber mallet close by to tighten them back. The brace is great for setting the width, but I found it takes away from the depth when picking up pallets. I'm pleased with them for the occasional use.

So far it seems to be working really good if it keeps working like this, I will raise my score to a 5 all the way across

I find that the pallet forks would be better if they actually bolted through the bucket. I can't get them tight enough to keep them from moving. I am satisfied with the weight that I can pick up with them

Forks great just dont fit my bucket well because of step on bucket. Other than that no problem If bucket was flat would mount great. I just got to build something so they will clamp more securely.

These 4000 lb. pallet forks should have come with a stabilizer bar to limit side to side movement, the same as the smaller forks. Also, the screw down rods (2 each fork) would be much better with a nut welded to the plate and the rod would then screw down into the nut. As it is the nut is attached to the screw rod, and as soon as the nut reaches the plate, the whole plate slips and slides sideways. This causes paint to be removed from the plate and constant repositioning of the plate while tightening.. This would not happen if the nut were attached to the plate as the rod would hold the nut and plate in place.

They work great for the price. I wouldn't push them too hard but I have lifted over 1000# without an issue. Would buy again for the price.

Pallet forks are well constructed and very solidly made Unfortunately, had trouble mounting on our tractor bucket being impossible to secure without using a pice of plywood under the clamp both to stop it slipping when tightening The forks could really benefit from having a connector bar between the two to stop side ways movement Other than that have been quite useful but need to stop and tighten after a few uses