Recenzje klientów dla widły do ​​palet VEVOR 1490x70x230mm karetka wideł 907kg nośność widły 149cm długość całkowita z ostrzem wideł 109,2cm wózek widłowy 495-915mm regulowane zęby wózka widłowego ładowacz czołowy rama paletowa

The center bar broke right away other than that work well

Kinda bulky, Used on my Backhoe loader probably over did it but bent one fork at the weld trying to lift some logs I cut up Good for light duty IMO but not 4000 lbs a Chevy weighs 3600 lbs LMAO

Forks are good but the bolts that clamp on the bucket bend very easy :( Maybe user error but I'm sure the were secure before I moved the logs and pallets Welds on nuts broke so maybe that was the problem and it happened on both forks at seperate times

I bought these forks because they looked like a perfect fit for my New Holland tractor. Looked perfect when unpacking however I ran into a problem. When trying to attach my lower control arms I found the holes drilled on the bracket were too close to the frame of the fork attachment. I could not put the pin in, the holes should have been an inch farther from the frame. Not sure if I should return or remove and weld on new steel brackets that are a little longer. I willl attach the picture. I the lower arm will be beside the bracket for the picture to show distance is not large enough

Item came as pictured, when unboxes i seen the box profile was 3mm wall, i expected 5-6mm wall for the rated weight it should handle, i will be welding on some flat to the sides for extra strength. The first time i used them the bolts to tighten to the bucket bent due to the gap allowing too much movement. I again will need to modify the gap and update the bolt size. Nice idea for a product but in my opinion as standard only fit for very light use.

Good product for the price and they work well. Only complaint is they do slide around your tractor bucket and don’t stay straight even when secured well.

Overall, product seemed to be a good product until however, I found the hardware used to tighten the forks to the bucket inferior because the "flange nut" intended to hold the forks firmly simply stops turning when it touches the buckets edge and the threaded rod it's attached to only applies pressure over a very small area and doesn't keep the forks from rotating out of alignment. In addition the crossbar intended to also help keep the forks from moving sideways is only held tight by a wingnut too small to tighten sufficiently to keep bar and forks alligned. I purchased this product to assist in picking up small limbs and branches around yard but proved to be insufficiently capable of staying aligned thus too much trouble without actually welding the forks to the crossbar.

I bought my forks about a month ago, when I received the box it was torn up and one of the yellow plates was missing. When I put it on the tractor, one of the screws was cross treaded and extremely hard to tighten. Other that that, quality is awesome and very well made. I would buy them again.

attache sur les bras de relevage trop courte, attache des fourche trop fragile

If I had it to do all over I would bought the ones that are connected but I just welded a piece of pipe to mine. They serve there purpose but the will shift one you no matter how tight you get them.