Recenzje klientów dla Zestaw do gwintowania VEVOR, gwintowniki maszynowe, 110 elementów, zestaw do gwintowania ze stali łożyskowej, wiertło rdzeniowe, maszynowe, gwintowniki, w tym 35 gwintowników, 35 wykrojników, futerał do przenoszenia, metryczny

A good range set for the money, if your a occasional user. The worst thing about it is the cheap plastic case. It doesn't hold the dies nor a good deal of the taps, so closing and opening is fraught with pieces flying all over the place. The tool handles are also cheap and loose their grip easily on the taps. Address those 2 shortcomings and it would score better

Does the job i needed it for

I just received this tap/die set. The taps are absolute junk with huge burrs on the leading edge of the flutes. If used, these taps would destroy a threaded hole. I didn’t expect real tool quality but expected that the taps would chase a thread. Do not buy these as they are by far the cheapest of the cheap.

Not good damaged thread on first die used and small screwdriver with the set was bent like a banana. Photo's will not upload from my phone.

Ive bought several tools from vevor over the last 3 years or so almost all of them have done exactly what i bought them for....the tap and die set not so much. First tap i used snapped off 3rd turn trying to cut threads into mild steel and took an hour to get it out. Tryed to use several die and they dont even clean up the threads already there. Completely destroyed a wheel stud trying to clean threads up. Will definately not buy again.

I did residence this tools, but I have not used this jet.

This item is not worth the money, don't buy their description of high-grade HRC55-62 hardened bearing steel, effortlessly handling heavy loads and high pressures, I tried to cut some threads on 3/16" rod and it would not cut them. I had used a tap & die set from Harbor Freight to cut the same size threads on the same rod about 2 months ago and it worked way better than this set from Vevor. I should have borrowed that die set again instead of buying my own

I have only used some of the the die not the tap but they have been very bad, I was going to thread an M14x1.25 in tha lathe today but it wouldn't cut, It doesn't even work well to just clean the threads of an existing screw, It is just as hard to screw the die on as it is to unscrew, just as if it doesn't cut

I brought this set to excange the set I brought cheap here in Norway. But this seem Even cheaper. The holders for the bits are sad and flimsy and will probably brake fast...

pessima qualità non ho potuto renderlo perchè lo ho provato dopo i termini di restituzione ma sono soldi buttati perchè le filiere non tagliano