Recenzje klientów dla Zestaw ściągaczy do rur VEVOR (9-częściowy) Ściągacze do rur ze stali chromowo-molibdenowej, z walizką, do usuwania uszkodzonych rur i złączek gwintowanych o średnicy od 3,2 do 25,4 mm, dla hydraulików i mechaników

Worked above and beyond expectations, snapped a Cam bolt out on a DOHC engine. Used center punch and kept using drill bits working up in size and backed itself out on its own just using the drill bits no extractor even needed. Note to future buyers do come oiled, would recommend wiping off before use to avoid slippery fingers from the oil.

First time I use the adaptor (reducer), it brakes. The extractors themselves seem to be fine

The adaptor crashed in 1 second when I want remove one wheel bolt from the car

NOT RESEVED !!!!!!!

Bought this set to remove broken chasis bolts but the quality proved to be very poor. Drill bits became dull after a few minutes. The extractor pieces broke inside the drilled bolts. Would absolutely Not recommend

Bought this tool set to extract a couple of broken bolts, high hopes of getting my issues but after several failed attempts of broken drill bits and stripped extracts, job failure. This is one of the WORST tool kits I have ever bought. Either type of extracts will grab a good enough bite to grip enough. This is the second product I have purchased from this site that has let me down, anymore defective products and I will not be shopping Vevor anymore. I give this product 2/10 only due to the price of product and decent delivery time. Parts quality 1/10.

Purchased this set with the intent of recovering 3 broken bolts from a 2013 Land Rover LR4. First two were 6mm bolts broken off from vibration in the timing chain. Using the reverse bits to first drill holes into the bolts and then driving the long thin extractor (1/8" socket style was too large) the bolts came out on the first attempts. I was two for two! Then a few days later I made an attempt on a broken m6x25 with a missing T30 torx head. Using the same method, drilled with smallest bit then next size up, drove extractor into hole. Attached wrench to extractor and began to apply pressure and the extractor exploded/shattered just above the bolt and now partially sticks out. Third time was not the charm! Now considering welding nut or attempting to extract the chromoly extractor by grinding with diamond dremel bits and trying again with a different manufacturers product! Quality of these bits is suspect and not sure I would recommend the product.

Great product except for the 1/2" die stripped out on me re threading a stud.

It still has not been delivered